LPCXpresso Motor Control Kit » EA-XPR-120
The LPCXpresso Motor Control Kit is a platform for low voltage motor control based on NXP’s LPCXpresso LPC1114 (included in kit), LPCXpresso LPC1343 and LPCXpresso LPC176x. This universal platform supports control of BLDC, BLAC, stepper and dual brushed DC motors.The LPCXpresso Motor Control Kit is ideal when you need to do prototyping work with motor control or to learn more about motor control. The board can be directly controlled by LPCXpresso LPC1114 (included in theis kit), LPC1343 orLPC176x target boards but it can also be controlled from any other MCU via an expansion connector. See the specification below for details.
Included in LPCXpresso Motor Control Kit:
- LPCXpresso Motor Control Board
- LPCXpresso LPC1114 with LPC-link (jtag) supported by LPCXpresso IDE
- BLDC motor with hall sensors
- 24V power supply (60W)
LPCXpresso Motor Control Board Specification
Controller MCU- Socket for LPCXpresso LPC1114 and LPC1343
- Socket for LPCXpresso LPC176x
- Socket for LPC1xxx in PLCC44
- Expansion connector for control by LPC1800/LPC4000/LPC2900 families, or other
- 4 phases (based on NXP PMSN2R6-40YS NMOSFET), accessed via screw terminals
- Phase control support 100% duty cycle
- Voltage measurement (on three phases and virtual ground)
- Current measurement (in-phase on three phases and common low-side)
- Input current measurement, including over-current trip
- Break functionality
- Hall & QEI sensor inputs, connected via screw terminals
- Temp sensor
- 12-30V input voltage, 17A max current (max 300W output)
- On-board 15W power supply (+11V, +5V, +3.3V)
- USB interface (must be supported by controlled MCU)
- Ethernet interface (must be supported by controlled MCU)
- CAN interface (must be supported by controlled MCU)
- RS422/485 interface
- UART-to-USB interface
- 5-key joystick switch
- 96x64 pixel OLED
- Reset pushbutton
- I2C-E2PROM
- SWD/JTAG connector
- 2.1mm input jack, or via screw terminals
- 12-30V, 17A max
- 200 x 150 mm
